Craftsman 987.799601 manual Dahger, Before Starting Engine, Step t ADD OIL to Engine

OPERATION

BEFORE STARTING ENGINE

STEP t: ADD OIL TO ENGINE

1, The machine was shipped without oil in the engine The engine requires approximately 2t ounces of oil

2, Only use high quality detergent oil rated with the APJ. service classification of "SF" or "SG" Select the

oil'sSAE viscosity grade according to your expected operating temperature:

NOTE: Change the oi! after the first two operating hours,. See "Changing Oil" on Page 27 in the "Customer

Responsibilities" section of this		Manual.
colder-_	32°F	_ warmer
5W30		SAE 30

NOTE: Although multi-viscosity oils (5W30, 10W30, etc), improve starting in cold weather, these multi-

viscosity oils will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil,

3, With the machine on level ground, remove the dipstick (A, Figure 18) and place it on a clean surface.

4, Using a clean funnel, slowly add oil to the dipstick hole. While adding oil, frequently reinstall dipstick (screw

dipstick down securely) to check oil level Wipe dipstick with a clean cloth before reinserting each time Fill to the "FULL" mark on dipstick. DO NOT OVERFILL!

5. Reinstall the dipstick securely

STEP 2" ADD GASOLINE TO THE FUEL TANK

Fill the fuel tank with fresh, clean, unleaded regular automotive gasoline. (Leaded regular and un}eaded premium grades of gasoline are acceptable substitutes.)

Q Do not mix oil with gasoline.

QDo not use gasoline left over from last season or stored for long periods,,

WARNING: Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids dufing storage. Acidic gas can damage the fuel system of an engine while in storage

To avoid engine problems, the fuel system should be emptied before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty Use fresh fuel next season° See STORAGE instructions for additional information.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

DAHaER

RotatingCuttingBladesWill Cause

Serious Personal Injury!

Do not allow handsor any part of the bodyor clothing inside the vacuum inlet, chipper chute, discharge

opening, or blower deflector opening when the engine is running.

Before inspecting or servicing any part of the machine, stop the engine and make sure that all moving parts have come to a complete stop° Disconnect the spark plug wire and secure it away from the spark plug.

A

Figure 18: Remove dipstick to add oil to engine,

DAHGER

Gasoline is highly flammable and its vapors are explosive° To prevent personal injury or property damage:

•Do not add fuel if the engine is runningor still hot

from recent operation. Allow the engine to cool for at least three minutes°

,* Do not fill the feel tank indoors. After filling.wipe up any spills and move the machine away from gasoline fumes beforestarting the engine.

•Do not allow open flames, matches, or smoking in areao

18