8.Use the humidity output regulator control knob to adjust the intensity of the vapor output. Turning the knob clockwise will increase the moisture output, turning the knob counterclockwise will reduce the moisture output.
(see Fig. 10)
Fig. 10
9.When the humidifier runs out of water the power light will turn red, and the mist output will stop. This is a safety feature to prevent the humidifier from possibly over heating and damaging the nebulizer. This safety feature uses a water level sensor to stop the nebulizer once the water level sinks below the required level in the water basin. Turn the humidifier off and unplug before removing and refilling the water tank. Please note that the Power Light on the humidifier body will stay on.
The (red) light signal indicates that the humidifier is turned on and needs to be refilled.
INSERTING HUMIDIFIER FILTER
(SOLD SEPARATELY not included with your humidifier)
A humidifier filter is an optional accessory for your Crane Cool Mist Humidifier. Filters are used to eliminate white dust caused by hard water and to reduce mold spores and bacteria that can build up in your humidifier.
Place humidifier filter in humidifier as shown in Fig. 10A
NOTE: Do not leave filter in humidifier longer than recommended time. See filter instructions on filter box packaging.
Filters are not included with the humidifier and can be purchased separately.
Fig. 10 A
SET THE CORRECT HUMIDITY OUTPUT
ALWAYS PLACE THE HUMIDIFIER ON AN ELEVATED
Adjust the vapor control so that the vapor rises up and gets absorbed by the room air. Do not turn on too high output as the vapor cannot be absorbed by the air and accumulates on the surface around the humidifier.
If the humidifier is placed near a fan or air conditioning outlet the vapor may be forced down by the foreign air stream.
Change the location of the humidifier or reduce the output of the other room conditioning appliances.
correct
wrong
7
