BELMONT WORK TABLE WITH STAINLESS STEEL TOP

crossbar

fixed shelf

leg B

STEP 1

leg A

leg A

leg B

2Fit pre-assembled dowels of crossbar into legs as shown. Loosely attach crossbar to each leg with 1 hex bolt, 1 spring washer,1 flat washer and 1 plastic washer. Do not fully tighten bolts.

fixed shelf

crossbar

STEP 2

3Step 1) Fit remaining leg (A) and leg (B) onto corre- sponding notches of fixed shelf and dowels of crossbar. Loosely attach each leg with 1 hex bolt, 1 spring washer and 1 flat washer. Do not fully tighten bolts.

Step 2) Loosely attach crossbar to each leg with 1 hex bolt, 1 spring washer,1 flat washer and 1 plastic washer.

tabletop

NOTE: Do not remove protective film until instructed

4Place tabletop upside down onto a clean, padded

surface. With the assistance of another adult, position leg assembly onto tabletop as shown. Attach each leg with

3allen bolts. Secure, but do not over tighten, the bolts with an allen wrench.

NOTE: Do not over tighten the bolts

5At this point, fully tighten all hex bolts with a hex wrench. Do not over tighten bolts.

Made in Thailand - r03

Customer Service 800.967.6696 Latest instructions available at www.crateandbarrel.com

Page 2 of 3