Crate & Barrel Farrow 44 Corner Media Stand top panel, front frame, and, Fit, legs, with, with, A) Place, B) Attach, C) Secure, top panel, top panel, large bolts, small bolts, front frame, small bolts

FARROW 44” CORNER MEDIA CONSOLE

NOTE: Do not over	A leg
tighten the bolts

A

bottom panel

B

C

B

bottom crossbar

1A) Place bottom panel onto a clean, padded surface. Attach 4 legs to bottom panel with 2 large bolts, 2 spring washers and 2 large flat washers per leg as shown. Secure, but do not over tighten, bolts using an allen wrench.

B) Attach 1 bottom crossbar to bottom panel with 2 small bolts, 2 spring washers and 2 small flat washers as shown, using a phillips head screwdriver.

C) Secure bottom crossbar to bottom panel with 1 large screw, using a screwdriver.

right back	right panel
panel

partition

left panel

left back panel

bottom panel

2With the assistance of another adult, fit pre-assembled dowels of left/right side panels, left/right back panels and partition into corresponding holes of bottom panel. Secure bottom panel with 11 large screws, using a screwdriver.

NOTE: Make sure crossbar of top panel is positioned towards the front of assembly as shown.

top panel

3Fit pre-assembled dowels of left/right side panels, left/right back panels and partition into corresponding holes of top panel. Attach top panel with 8 small bolts, 8 spring washers and 8 small flat washers as shown, using a screwdriver.

front frame

4With the assistance of another adult, position assembled unit upright. Attach front frame to assembled unit with 12 small bolts, 12 spring washers and 12 small flat washers as shown, using a screwdriver.

Made in Vietnam - r03 Customer Service 800.967.6696 Latest instructions available at www.crateandbarrel.com Page 2 of 4