KENTON CUBE WITH 2 DRAWERS
NOTE:
Do not over tighten the screws.
Depress plastic tab to detach small glide from large glide assembly
2Remove the small component of each glide assembly. Attach 2 of the large glides to the left and right side panels with 3 small screws per glide, orienting each glide as shown. The front of each glide should sit approximately 3/4" from the front edge of the panel. Secure, but do not over tighten each screw with a phillips head screwdriver.
A
C
B
3A. Insert 4 cam screws in both end panels. Secure, but do not over tighten with a phillips head screwdriver.
B. Place side panels into position over 1 bottom panel, making sure slots on side panels line up with slot on bottom panel. Align dowels and cam screws and firmly press into position.
C. Slide back panel into the corresponding slot in the bottom & side panels.
Cam in | Cam in |
unlocked | locked |
position | position |
4Using a phillips head screwdriver, turn each cam at the base of the side panels clockwise until each cam tightly engages the cam screw.
Made in China - r07
5Repeat Steps 3 and 4 for attachment of the top panel. Be sure that back panel is seated in the slot at the back of the top panel before securing the 4 cams.
Page 2 of 3
Customer Service