Crate & Barrel Ledge 6-Drawer Dresser and, cam, into, into, cams, legs, into, Insert, A) Place, as shown, B) Insert, partition, support leg, bottom panel, large screws, bottom panel

LEDGE 6 DRAWER DRESSER

B	NOTE: Do not over
	tighten the cam screw

A	left and right
	side panels

partition

C

1A) Place left and right side panels onto a clean, padded surface. Insert 6 wood dowels into left and right side panels as shown.

B) Insert 2 cam screws into left and right side panels as shown. Secure, but do not over tighten, cam screw with a phillips head screwdriver.

C) Insert 4 cams into partition as shown.

NOTE: Do not over	B	support leg
tighten screws
		adhesive
		foot

A

base

bottom panel

2A) Attach base assembly to bottom panel with 12 large screws as shown. Secure, but do not over tighten, screws using a phillips head screwdriver. B) Attach support leg to bottom panel by turning support leg clockwise.

C) Adhere 5 adhesive feet to legs as shown.

NOTE: Make sure arrows on each cam point towards nearest edge with holes

back crossbar

front crossbar

3Insert 2 wood dowels and 2 cams into front and back crossbars as shown. Make sure arrows on each cam point towards nearest edge with holes.

left side panel

partition	right
	side
	panel

left front crossbar

right front

left backcrossbar crossbar

right back crossbar

4With the assistance of another adult, fit dowels of front and back crossbars into corresponding holes of left/right side panel and partition as shown. Using a screwdriver, turn each cam clockwise until it securely engages each cam screw.

Made in Malaysia - r10 Customer Service 800.967.6696 Latest instructions available at www.crateandbarrel.com Page 2 of 4