OCTAVE FOUR DRAWER CHEST
flat washer
spring washer 
small bolt
leg assembly
5Attach leg assembly to bottom of assembled unit with 8 small bolts, 8 spring washers and 8 flat washers as shown. Secure bolts with a screwdriver. With the assistance of another adult, carefully position unit upright.
| B |
|
A |
|
|
|
| top drawer |
|
| right side |
| top drawer |
|
| back |
|
| drawer | B |
top drawer | bottom | |
| ||
left side |
| pull |
|
| |
|
| top drawer |
|
| front |
A |
| C |
|
| |
NOTE: Make |
| crossbar |
sure wheels are |
|
|
at the back
6A) Fit drawer bottom into grooves of drawer back and top drawer front as shown. Fit dowels of drawer assembly into corresponding holes of top drawer sides. Secure with
4screws per side, using a screwdriver.
B) Attach crossbar to drawer assembly with 4 screws.
C) Attach 2 pulls to top drawer front with 2 pull bolts per pull, using a screwdriver.
A | B |
| drawer right |
| side |
| drawer |
NOTE: Make | back |
| |
sure wheels are | drawer |
at the back | |
| bottom |
| pull |
| drawer |
| front |
drawer left | C |
| |
side | crossbar |
|
7A) Fit drawer bottom into grooves of drawer back and drawer front as shown. Fit dowels of drawer assembly into corresponding holes of drawer sides. Secure with
4screws per side, using a screwdriver.
B) Attach crossbar to drawer assembly with 4 screws. C) Attach 2 pulls to drawer front with 2 pull bolts per bolt using a screwdriver.
Repeat step 7A-C for remaining drawer assembly.
8Insert drawer assembly into the case, fitting wheels of drawer glide into rail of case glides.
Repeat step 8 for remaining drawer assembly. Assembly is now complete.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Do not use furniture wax or polish as the unit is finished with a protective clear lacquer. It is recommended to use coasters to protect surface from heat and water.
Made in Vietnam - r04
Customer Service 800.967.6696 Latest instructions available at www.crateandbarrel.com
Page 3 of 3