| CA125D Acoustic Amplifier |
Technical Specifications: |
|
Output Power Rating: | 125 watts RMS total system power |
Woofer Amp: | 2 x 50 watts RMS @1% THD |
Tweeter Amp: | 25 watts RMS @1% THD |
Inst. Channel: Low: | |
Mid: | |
High: | |
Input Impedance: | 25k ohm (Active), 2.2M ohm (Piezo) |
Input Sensitivity: | 22mV RMS (Active), 9mV RMS (Piezo) |
Sens. to Eff Send/Line out: | 70mV |
Max Input Signal: | 6V RMS (17V peak to peak) |
Feedback Elimination: | Freq: variable from 80Hz to 4kHz |
| Cut: variable from |
Voc./Mic Ch: Input Impedance: | 3k ohm |
Input Sensitivity: | 3mV RMS |
Sens. to Eff Send/Line out: | 9mV |
Max Input Signal: | 10V RMS (28v peak to peak) |
Aux. Ch: Input Impedance: | 20k ohm |
Input Sensitivity: | 15mV RMS |
Sens. to Eff Send/Line out: | 50mV |
Max Input Signal: | 10V RMS (28V peak to peak) |
Master EQ’s: | |
Effects Loop: | Line Out 1V RMS, Line In 1V RMS |
Eff Return to Line Out Sens: | 50mV |
Eff Return In. Impedance: | 11k ohm |
Eff Send Out. Impedance: | 2.2k ohm |
Line Out Out. Impedance: | 220 ohm |
Internal Woofers: | 2 x 8” w/polypropylene cones, rubber surrounds, 30oz magnet, 1” voice coil, |
| 8 ohms, 50w RMS, 95dB 1w 1m |
Internal Tweeter: | High efficiency Piezo, 110dB 1w 1m |
Internal Crossover: | Active electronic type |
Power Requirements: | 100VAC, 50/60Hz, 160VA; 120VAC, 60Hz, 160VA; 230VAC, 50Hz, 160VA; |
| 230VAC, 50Hz, 160VA |
Size and Weight: |
Crate continually develops new products, as well as improves existing ones. For this reason,
the specifications and information in this manual are subject to change without notice.
www.crateamps.com
©2004 SLM Electronics
A Division of St. Louis Music Co.
1400 Ferguson Avenue
St. Louis, MO 63133