Crate Amplifiers CMX62 manual Stereo Input Channels 7

CMX62 Stereo Console Mixer

The Stereo Input Channels (7 – 10):

19

20

21 22

23

24 25

26

27

28

29

30

31 32

18LEFT/MONO: A Tip/Sleeve 1/4” jack for instruments, drum machines, tape/CD chan- nels and similar high impedance signals. For stereo inputs use this jack for the left channel input and the Right jack (#19) for the right channel input. For mono inputs use this jack only.

19RIGHT: A Tip/Sleeve 1/4” jack for instruments, drum machines, tape/CD channels and similar high impedance signals. For stereo inputs use this jack for the right chan- nel input and the Left/Mono jack (#18) for the left channel input. For mono inputs use the Left/Mono jack (#18) only.

20HIGH: Controls the high frequency level for the channel. Allows ±15dB @ 12kHz. Shelving type.

21MID: Controls the middle frequency level for the channel. Allows ±15dB @ 800Hz. Bandpass type

22+4/-10 SWITCH: This sets the input sensitivity of the channel to either +4dBv for use with professional equipment (such as DAT players, mic preamps, etc.) or -10dBv for use with semi-pro equipment (such as tape decks, CD players, etc.).

23LOW: This controls the low frequency level for the channel. Allows ±15dB @ 70Hz. Shelving type.

•Additional EQ information is on page 14.

24AUX: Controls the level of the signal sent from the channel to the Aux Out master control (#49). Use as a monitor send (Pre/Post switch, #25, in the “Pre” position) or as an effects loop send (Pre/Post switch, #25, in the “Post” position).

25PRE/POST: The signal sent by the Aux control (#24) can be set to either pre-fader (switch in the “Pre” position) or post-fader (switch in the “Post” position).

26EFF: Controls the level of the signal sent from the channel to the Eff Out master con- trol (#50). Use as an effects loop send.

27BAL: Divides the signal proportionally between the left and right channels of the Main L/R fader (#60) or the Group 1/2 faders (#59), depending on the setting of the Grp / L/R switch (#31).

28PEAK LED: Illuminates when the input signal level is within 6dB of clipping. Proper setting of the input signal level and the +4/-10 switch (#22) will cause this LED to flash only on strong input signals.

29-20dB LED: Illuminates when the input signal level is above -20dBv. This serves as a “signal present” LED.

30PFL: This switch, when depressed, sends the channel’s signal to the Monitor master control (#51). The Output LED Meters (#57) are also switched to monitor this signal, which is pre-fader. The PFL LED (#55) illuminates to indicate that the Headphones (#39), Monitor (#42) and LED Meters (#57) are now responding to the PFL selection.

31GRP / L/R: This switch determines whether the signal is sent to the Group 1/2 master faders (#59) or the Main L/R master fader (#60).

32FADER: Controls the level of the signal sent to either the Main L/R fader (#60) or the Group 1/2 faders (#59), depending on the setting of the Grp / L/R switch (#31).

5