Crate Amplifiers GLX65, GLX212, GLX120 manual Front Panel

GLX65/120/212 Guitar Amplifier with DSP & ChannelTracking

The Front Panel:

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

1:MUTE: This switch, when depressed, silences the input signal. The Tuner (#21) remains active when this switch is depressed.

2.INPUT: Use this 1/4” jack to connect your guitar to the amplifier by means of a shielded instrument cable.

SOLO CHANNEL: A high gain channel giving you sounds with serious overdrive.

3:GAIN: Use this control to adjust the amount of distortion for the Solo channel.

4:SHAPE: Use this control to “dial in” the tone for the Solo channel. Rotating the control counterclockwise enhances the mid frequencies, while rotating the control clockwise enhances the low and high frequencies.

5:LEVEL: Use this control to adjust the output level of the Solo channel.

6:SOLO/RHYTHM SELECT: Use this switch to select the Solo or Rhythm channel. When this switch is depressed, the Solo channel is selected. With the switch in the out position, the Rhythm channel is selected. This switch is active only when the Solo-Rhythm/Clean Select switch (#12) is depressed.

7:GAIN: Use this control to adjust the amount of distortion for the Rhythm channel.

8:LOW: Use this control to adjust the low frequency level of the Rhythm channel.

9:MID: Use this control to adjust the midrange frequency level of the Rhythm channel.

10:HIGH: Use this control to adjust the high frequency level of the Rhythm channel.

11:LEVEL: Use this control to adjust the output level of the Rhythm channel.

12:SOLO-RHYTHM/CLEAN SELECT: Use this switch to select the Clean channel or the Solo and Rhythm channels. With the switch in the out position, the Clean channel is selected. When the switch is depressed, either the Solo or Rhythm channel is selected, depending on the setting of the Solo/Rhythm Select switch (#6).

CLEAN CHANNEL: A normal gain channel designed to give you crystal clean sounds.

13:VOL: Use this control to adjust the output level of the Clean channel.

14:LOW: Use this control to adjust the low frequency level of the Clean channel.

15:MID: Use this control to adjust the midrange frequency level of the Clean channel.

16:HIGH: Use this control to adjust the high frequency level of the Clean channel.

17:DSP LEVEL: Use this control to adjust the amount of digital effect: in its fully counterclockwise position the signal will be “dry” (without any effect). As you rotate the control clockwise the amount of effect increases.

18:DSP MODE: Use this control to select one of the 16 built-in digital effects. A listing of the effects is shown on page 3 of this manual.

19:LIGHTS: Use this switch to turn the front panel illumination on (top of the switch depressed) and offf (bot- tom of the switch depressed).

20:POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch 4 depressed).