Crate Amplifiers V32 manual Rear Panel not shown

V32 GUITAR AMPLIFIER

The Rear Panel (not shown):

15.AC Line Cord: The grounded power cord should only be plugged into a grounded power outlet that meets all applicable electrical codes and is compatible with the voltage, power, and frequency requirements stated on the rear panel. Do not attempt to defeat the safety ground connection.

16.Line Out: Use this 1/4” jack to send a line level signal to a mixing board, external power amplifier or powered monitor, or to the input jack of an external signal processor.

17.Line In: Use this 1/4” jack to connect the output of an external effects processor to the amplifier.

18.8 Ohm Speaker: The V32 is shipped with a cable connected from this jack to the internal speaker. To connect the amplifier to an external speaker cabinet, disconnect the cable from the amplifier and use the jack to connect the exter- nal cabinet to the amplifier by means of a heavy duty Class 2 wiring speaker cable termi- nated with 1/4” plugs. The total impedance rat- ing for the external speaker(s) must be 8 ohms.

19.Footswitch: Use this jack to connect the supplied two-button footswitch for remote control of channel switching and the Boost function. The front panel Clean/Overdrive and Boost switches (#3, #6) are inoperative when a footswitch is con- nected.

5