V32 GUITAR AMPLIFIER

The Front Panel:

1

2

3

4

5

6

7

8

9

10

11

12

13

14

1.Input: Connect your instrument here by means of a shielded signal cable.

2.Clean Volume: Use this control to adjust the output level of the Clean Channel.

3.Clean/Overdrive: This switch, when de- pressed, selects the Overdrive Channel. When this switch is in the out position, the Clean Channel is selected.

4.Overdrive Gain: Use this control to adjust the gain of the Overdrive Channel. With the control towards the counter clockwise posi- tion, the gain is low and very little distortion is present. As you rotate the control clockwise the gain increases, producing more overdrive distortion and a higher output volume level.

5.Treble: Use this control to adjust the out- put level of the high frequencies. This control provides 12dB of cut or boost at 6kHz.

6.Boost: This switch, when depressed, increases the output by 10dB at 900Hz, giv- ing the middle frequencies more punch.

7.Mid: Use this control to adjust the output level of the middle frequencies. This control provides 10dB of cut or boost at 1kHz.

8.Bass: Use this control to adjust the output level of the low frequencies. This control pro- vides 8dB of cut or boost at 150Hz.

9.Presence: This switch, when depressed, increases the output level of the high fre- quencies by 8dB at 10kHz, giving a more “glassy” sound to the amplifier. This helps the output of the amplifier cut through “acousti- cally dead” rooms.

10.Overdrive Level: Use this control to adjust the output level of the Overdrive Channel.

11.Reverb: Use this control to adjust the amount of reverberation applied to the sig-nal. With the control fully counter clockwise no reverb is applied. As you rotate the con-trol clockwise the amount of reverb increas-es.

12.Lamp: This lamp illuminates when the amplifier is turned on.

13.On/Standby: Use this switch to activate the amplifier. The On/Off switch (#14) should be turned on first. Allow 20 seconds for the amplifier to warm up before turning the Standby switch on.

14.On/Off: Use this switch to turn the ampli- fier on and off. This switch should be turned on at least 20 seconds before turning the Standby switch (#13) on.

4

Page 4
Image 4
Crate Amplifiers V32 manual Front Panel, Lamp This lamp illuminates when the amplifier is turned on