Creda S077E manual Installation of Built-in Ovens

Installation

The appliance must be installed only by a qualified per- son in compliance with the instructions provided. The manufacturer declines all responsibility for improper installa- tion which may harm persons and animals and damage property.

Important: The power supply to the appliance must be cut off before any adjustments or maintenance work is done on it.

Installation of Built-in Ovens

In order to ensure that the built-in appliance functions prop- erly, the cabinet containing it must be appropriate. The figure below gives the dimensions of the cut-out for installation un- der the counter or in a wall cabinet unit.

			mm.23				.	mm.
					45	mm
mm.595				mm.567		558	mm.	593
			5 mm.
	595	mm.		.
			545	mm
		.
		mm
	24

N.B.: Installation in compliance with the consumption declaration

	.
45	mm
	.
min

mm.595			23 mm.	.mm567			585-575mm.	595mm.		.
					558				45	mm
						mm.				.
										min
			5 mm.
	595	mm.		.
			545	mm
		.
		mm
	24

In order to ensure adequate ventilation, the back panel of the cabinet unit must be removed. Installing the oven so that it rests on two strips of wood is preferable. If the oven rests on a continuous, flat surface, there must be an aperture of at least 45 x 560 mm.

.	45	mm.
mm
560

The panels of the adjacent cabinets must be made of heat- resistant material. In particular, cabinets with a veneer exte- rior must be assembled with glues which can withstand temperatures of up to 100 °C.

In compliance with current safety standards, contact with the electrical parts of the oven must not be possible once it has been installed.

All parts which ensure the safe operation of the appliance must be removable only with the aid of a tool.

For the correct centring of your appliance, position the 4 tabs on the sides of the oven in correspondence with the 4 holes on the perimeter of the frame. In particular, if the cabinet side panel:

•is 20 mm thick: the removable part of the tab must be removed (Fig. A);

•is 18 mm thick: use the first groove, which is factory-set (Fig. B);

•is 16 mm thick: use the second groove (Fig.C)

Fig. A Fig. B

Fig. C

To fasten the oven to the cabinet, open the door of the oven and attach it by inserting the 4 wood screws into the 4 holes located on the perimeter of the frame.

14