INPUT AND OUTPUT CONNECTION
The OBH 21/21SE is not designed to be connected to the high level speaker output of an integrated or power amplifier. Output level is controlled by the high quality volume control on the front panel.
The OBH 21/21SE has two pairs of stereo phono sockets (RCA jacks) on the rear panel. The first pair is the input from any line level source direct from the source or via the tape output of an amplifier. The second pair of sockets marked ‘output’ are to chain link the signal on to the next component in the system. Therefore the OBH 21/21SE can be driven from the Tape Output of an amplifier and the second set of sockets can be used to link the signal to the Tape Recorder input.
POWER SUPPLY REQUIREMENTS
In common with all electrical appliances, the OBH 21/21SE requires a power supply.
The requirement for the OBH 21/21SE is for 24 Volts DC at
150mA. A custom Creek power supply
The power supply which has been provided is a switchable supply with a universal input range of 100 – 240 Volts. The
NOTE
Due to the circuitry charging up it is normal to hear a small thump through the headphones during
It is necessary for the OBH 21/21SE to be ‘burned in’ for at least 24 hours before its full sound quality potential can be realised.The on/off switch is located on the rear panel. As the OBH 21/21SE draws very little power it may be left switched on permanently.
INSTALLATION AND OPERATION
Connect the Creek Uni power supply adaptor to the mains socket. Find a suitable place for the OBH 21/21SE and plug the DC power lead into the rear panel DC jack socket.
Connect a pair of high quality interconnect cables from the output of the source to the input sockets on the rear of the OBH 21/21SE.
There are several wiring options.
OPTION A
Connect directly from the output of a CD player to the input of the headphone amplifier
OPTION B
Connect the output of the CD player to the input of the headphone amplifier (as in Option A) Then connect the output of the headphone amplifier to the input of a stereo amplifier.
OPTION C
Connect the output of a CD player to the input of a stereo amplifier. Connect the output of the stereo amplifier to the input of the headphone amplifier (as in Option B). Then connect the output of a tape deck to the input of the stereo amplifier and the output of the headphone amplifier to the input of the tape deck.
Plug the headphones into the socket on the front panel. If you are using the OBH 21/21SE with two pairs of headphones, the output from each socket will be identical. However, if you are using only one pair of headphones, the impedance on each socket will be different. This feature is designed to give a better match with your particular headphones.
Try each socket to determine the best results.
Push the On/Off button on the rear panel to power up the headphone amplifier. the small green LED on the front panel will light when it is ready for use.
