Crestron electronic C2N-TFM

Crestron C2N-TFM FM Radio Tuner

Operations Guide - DOC. 6233A FM Radio Tuner: C2N-TFM • 25

C2N-TFM FM Tuner RDS Information Input and Output Signal Descriptions

SIGNAL TYPE AND

NAME DESCRIPTION

Analog input:

Each FM RDS/RBDS report code can be enabled

or disabled by setting the individual bits to high

(enable) or low (disable).

Bit0 = PI Code report - not supported Bit1 = PTY

(Program Type) Code report - enabled by default

Bit2 = PS (Program Service) Code report code -

enabled by default

Bit3 = Extended Country Code report - not

supported

Bit4 = Language Code report - not supported

Bit5 = Emergency Channel Code report - not

supported

Bit6 = Clock Year Code report - enabled by default

Bit7 = Clock Month Code report - enabled by

default

Bit8 = Clock Day Code report - enabled by default

Bit9 = Clock Hour Code report - enabled by default

Bit10 = Clock Minute Code report - enabled by

default

Bit11 = Clock Offset Code report - enabled by

default

Bit12 = Radio Text report - enabled by default

Bit13 = PTYN (Program Type Name) Text report -

enabled by default

Bit14 = TA (Traffic Announcement) Code report -

enabled by default

Bit15 = TP (Traffic Program) code report - enabled

by default

Analog input:

Selects a PTN code (program type number) to

search. There are 31 different program categories

available for selection. The categories differ

depending on whether the tuner is in US or

European mode.

Valid values range from 1 to 31. Refer to the table

at the end of this topic for a table of codes and

their corresponding categories.

Setting this analog value to a valid PTN initiates

the search. The search operation stops when:

1) a station is found with the given category; or

2) the Tune, Scan, TA/TP Search, or Band mode

buttons are pressed; or

3) the maximum loop counter has been reached.

Sending a new analog value will cancel the current

search and initiate a new search.

(continued on next page)