Crestron electronic C2N-TFM FM Radio Tuner Crestron C2N-TFM , Uploading a SIMPL Windows Program

FM Radio Tuner Crestron C2N-TFM

36 • FM Radio Tuner: C2N-TFM Operations Guide - DOC. 6233A

NOTE: The parameters shown in the previous illustration are the port settings for a

2-Series control system. Consult the Operations Guide for the control system being

used for exact parameter selection.

4. To verify communication, select Diagnostics | Establish

Communications (Find Rack). This should display a window that

gives the COM port and baud rate. If communication cannot be

established, refer to the “Troubleshooting Communications” section in

the respective Operations Guide for the control system.

Uploading a SIMPL Windows Program

A control system source file has

the extension .smw. A compiled

SIMPL Windows file has the

extension .spz for a 2-Series

control system, .bin for CNX

generation, and .csz for CNX

generation with SIMPL+.

The SIMPL Windows file can be uploaded to the control system using SIMPL

Windows or via the Crestron Viewport.

1. Start SIMPL Windows.

2. Select File | Open to view the “Open” window, navigate to the SIMPL

Window file (.smw), and click Open.

3. Select Project | Transfer Program.

1. Verify that the procedure for “Communication Settings” that begins on

page 34 has been performed.

2. As shown after this step, select File Transfer | Send Program

(alternatively, press Alt+P) from the Viewport menu.

File Transfer | Send Program Command

3. The “Send Program” window appears, as shown after this step. Click

Browse, locate the compiled file (.spz for PRO2), and click Open. This

will display the program's header information and enable one or both of

the What to Send check boxes. If the program does not contain any

SIMPL+ modules, only the SIMPL Program check box will be

enabled. If it does contain SIMPL+ modules, then the SIMPL+

Program(s) check box will also be enabled. Select one or both check

boxes and then click Send Program to begin the transfer.

NOTE: Refer to the respective Operations Guide for the control system for details

about the other fields shown on the “Send Program” window.