Crestron CNRFGWA Wireless RF Receiver
Operations Guide - DOC. 8086A Wireless RF Receiver: CNRFGWA • 3
Physical View of CNRFGWA Detail Views of CNRFGWA
The bottom panel of the CNRFGWA contains a Cresnet port and two miniature
rotary switches. (Labeling for the connector and switches is on the front face of the
unit.) Refer to the diagram on the previous page and descriptions that follow.
NET (FOUR-WIRE CRESNET) This 4-pin connector is used to connect the CNRFGWA to other four-wire devices in
the Cresnet system.
ID CODE (HI LO SWITCHES) These two rotary switches are used to set the unit’s network identity code. Refer to
“Identity Code” on page 5 for details.
CNRFGWA Indicators Three LEDs located on the front panel of the CNRFGWA indicate the unit’s status.
Refer to the descriptions on the next page.
433.92 MHZ
50
MODEL: CNRFGWA
CRESTRON
ANTENNA
NET POWER
I.D. SELECT
SIGNAL
NET
24
YZG LO
ID CODE
HI
INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
ANY INTERFERENCE RECEIVED,
AND (2) THIS DEVICE MUST ACCEPT
NOT CAUSE HARMFUL INTERFERENCE,
CONDITIONS: (1) THIS DEVICE MAY
SUBJECT TO THE FOLLOWING TWO
OF THE FCC RULES. OPERATION IS
THIS DEVICE COMPLIES WITH PART 15
FCC ID: EROCNRFGWA
7.28 in
(18.49 cm)
1.30 in
(3.44 cm)
3.25 in
(8.25 cm)
7.92 in
(20.12 cm)
Bottom
Front