Crestron electronic DIN-PWS50 Problem Solving

Crestron DIN-PWS50 DIN Rail 50 Watt Cresnet® Power Supply

Problem Solving

The following table provides corrective action for possible trouble

situations. If further assistance is required, please contact a Crestron

customer service representative.

DIN-PWS50 Troubleshooting

24VDC LED

does not

illuminate.

DIN-PWS50 is not

receiving power.

Verify the DIN-PWS50

is connected to an AC

power line.

Fuse is blown. Replace fuse with

T3.15AH (5 x 20 mm,

250 V, 3.15 A, time

lag, ceramic

cartridge). Refer to

“Fuse Replacement”

on page 12.

Output is

short-circuited.

Disconnect all output

connectors. LED will

light if problem was a

short circuit on output.

Operations & Installation Guide – DOC. 6667A DIN Rail Power Supply: DIN-PWS50 • 13

Contents

Main This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Crestron DIN-PWS50 DIN Rail 50 Watt Cresnet Power Supply Contents Page Crestron DIN-PWS50 DIN Rail 50 Watt Cresnet Power Supply Crestron Green Light DIN Rail 50 Watt Cresnet Power Supply: DIN-PWS50 Introduction Features and Functions Applications Specifications SPECIFICATION DETAILS Page Page # CONNECTORS*, CONTROLS & INDICATORS DESCRIPTION Industry Compliance Setup Network Wiring Installation Page Hardware Hookup Page Page Problem Solving Troubleshooting TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION Check Network Wiring Further Inquiries Future Updates Return and Warranty Policies Merchandise Returns / Repair Service 16 DIN Rail Power Supply: DIN-PWS50 Operations & Installation Guide DOC. 6667A CRESTRON Limited Warranty Page Page Page Crestron Electronics, Inc. Operations & Installation Guide DOC. 6667A