QuickMedia™ Matrix Switcher/Mixer Crestron QM-MD5x1
NOTE: Returned values match values that were selected for the VideoInpSelect
and AudioInpSelect inputs.
QM-MD5x1, Slot 1 Serial Output Signal Descriptions
OUTPUT DESCRIPTION
Control-FB$ Sends out unsolicited changes that occur within
the MD5x1 and provides complete switch
feedback when queried. Refer to “Appendix:
Serial Protocol” on page 64.
Slot 2: Remote Microphone Controls NOTE: This slot is operative only if Auto Compensation is NOT enabled. If Auto
Compensation is enabled (via the EnableAudioAutoComp input on Slot 05 –
General Audio Controls), then this signifies that the microphone trims that are stored
at the QM origination point will be propagated to the MD5x1.
The MD5x1 provides a QM input, labeled IN 5. The QM input contains two remote
microphone channels called MIC A-1 and MIC A-2.
The MD5x1 can mix MIC A-1 and MIC A-2 and switch the resulting Mic Mix to the
MIC 1 channel of the QM output, OUT. The same mic mix can be routed to the
mixer section of the line-level audio output, labeled AUDIO OUT.
The MD5x1 provides four bands of equalization (160Hz, 500Hz, 1.2kHz, and 3kHz)
for MIC A-1 and MIC A-2.
The MD5x1 provides up to 16 EQ trim presets, where a trim preset is a set of eight
EQ trims (four trims each for MIC A-1 and MIC A-2). This way, the system can
save and recall presets for each microphone in a QM origination point.
While using the SIMPL Windows programming manager, double-click on Slot 2 of
the QM-MD5x1 to view the details of the Remote Microphone EQ Controls symbol
as shown in the following diagram.
34 • QuickMedia™ Matrix Switcher/Mixer: QM-MD5x1 Operations Guide - DOC. 6300