Crimestopper Security Products CS-2000DPII manual OPTION PROGRAMMING Cont, Active Re-Arming

Models: CS-2000DPII

1 20
Download 20 pages 54.49 Kb
Page 10
Image 10
OPTION PROGRAMMING Cont.

OPTION PROGRAMMING Cont.

6. ACTIVE RE-ARMING

Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door has not been opened. This is handy if the vehicle is accidentally disarmed (via the Transmitter in your pocket) without you knowing it.

7. DOUBLE UNLOCK PULSE

The unit will send 2 unlock pulses when the #2 Unlock button is pressed. This feature may be required for interfacing this alarm with an existing Factory Keyless Entry or Alarm system in a vehicle. These systems are found on some Nissan, VW, Toyota, and Lexus vehicles.

8. SILENT ARMING DISARMING ( CHIRP DEFEAT )

With this feature, the system can be programmed to Arm and Disarm without the siren chirp using the regular Lock/Unlock Button. Flashing parking lights will be the only Arm/Disarm confirmation.

9. PARKING LIGHTS ON WITH DISARM

Keeps parking lights on instead of 2 flashes when system is disarmed to assist in locating your vehicle in a crowded parking lot or structure. Light will stay on for 30 Sec. or until Ignition is turned on.

10. DISARM WITH AUX. OUTPUT 1 ( TRUNK POP )

Controls whether the system will DISARM when the trunk pop / AUX. feature is used. When the option is turned on, the alarm disarms when opening trunk or using an AUX. device controlled by the Gray output wire.

11. SILENT ARM / DISARM WITH REMOTE BUTTON #2 ( QUICK PRESS )

With this feature, the system can be programmed to Arm and Disarm without a siren chirp using a short press and release of Button #2 on the remote transmitter.

12. DOOR LOCK/UNLOCK PULSE TIME

Controls the amount of time (0.75 sec. or 3 sec.) for the lock/unlock pulse. The 3 sec. setting may be required for 1980’/90’s European Vehicles that require a long pulse to do Vacuum door lock systems.

13. ACTIVE, PASSIVE, or FULL TIME CARJACK PROTECTION

This feature controls the type of Carjack protection the alarm will provide. There are 3 selections: Button 1 (Lock) = Active protection. Button 2 (Unlock) = Active and Passive protection. Buttons (1+2) = Full-Time protection. Option number 14 must be enabled to allow Carjack functions to operate.

10

Page 10
Image 10
Crimestopper Security Products CS-2000DPII manual OPTION PROGRAMMING Cont, Active Re-Arming, Double Unlock Pulse