Crimestopper Security Products SP-100 Sensor Adjustment, BROWN WIRE + SIREN OUTPUT 3 Amp Max

WIRING

ORANGE WIRE: (-) NEGATIVE ARMED OUTPUT / STARTER DISABLE (500mA Ground, Optional)

This wire becomes a (-) Ground Output when the System is Armed. This output is used for disabling the starter or to activate optional devices such as extra sensors, LED’s, window roll-up modules, voice modules etc. For Starter Kill, cut starter wire and connect between 87A and 30 on relay. Connect orange wire to 85 and connect 86 to an Ignition source that has voltage in the ON and CRANKING position. (See wiring diagram for relay configuration page 16)

BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)

Connect to RED siren wire from the Siren in the engine compartment.

WHITE WIRE: Two 12V FLASHING LIGHT OUTPUTS (7.5 Amp x 2)

Connect to the switched parking light wire at back of light switch. If this is not possible, connect directly to one of the parking lights at the front of the vehicle. Some vehicles require separate right and left circuits. Use the one White wire for each circuit (Use separate 7.5Amp fuse for each circuit).

RED WIRE: 12V POWER INPUT (15 amp fuse)

Connect to 12 Volt source with supplied fuse & holder. Recommended location for this connection is at the vehicle battery positive terminal.

2 PIN PLUG (WHITE): VALET PROGRAM and OVERRIDE PUSH-BUTTON

2 PIN PLUG (RED): ALARM STATUS LED INDICATOR

4 PIN SENSOR PLUG (RED):	SHOCK SENSOR: The sensor supplied with
GREEN Wire: Negative Trigger.
	this system does not require any additional
WHITE Wire: Negative Warn-A-Way.
	wiring. Simply mount the sensor in a suitable
BLACK Wire: Sensor Ground.
	location, plug it in, and adjust the sensitivity.
RED Wire: Sensor 12V Power.

SENSOR ADJUSTMENT

Clockwise = Higher Sensitivity

Counter Clockwise = Lower Sensitivity

5