Video output to monitor
I/R Camera
Black, Ground
Red, power input 12V (+) from reverse light
12 PIN (M) | 4 PIN (M) |
12 PIN (F) | 4 PIN (F) |
|
Diagram
2.In most cases and as a time saver, connect the camera power wire at the rear of vehicle behind the reverse lights. The red power wire line goes to the reverse light + 12 V and the black wire to ground.
3.Please carefully choose a path to route and hide the camera cable. Drilling a cable hole if necessary.
4.Please make sure to use the rubber grommet or plug to make a watertight seal for the cable where it passes into the vehicle body.
5.Please refer to the monitor wiring diagram. The monitor must be connected using its own power line and should not be connected to same power line with the camera.
Step 5: Test Run Your New Rear View Camera System
1.You have just completed the installation and wiring of your new rear view camera system.
2.Please make sure the vehicle is parked at a safe place before you do a test run.
3.Power up your vehicle and the monitor. Put the vehicle in reverse and the monitor should immediately display a clear, color picture.
Important: The rear view camera will be used when the vehicle is in reverse gear. If the monitor does not display a picture or the picture quality not satisfactory, please double check all cable connections. If you are unable to correct the problem, please contact your supplier for help.
1770 SOUTH TAPO STREET ª SIMI VALLEY, CALIFORNIA 93063
WWW.CRIMESTOPPER.COM
Page 5 of 6
