Before Setting Oven Controls
Oven Vent Location
For models equipped with coiled surface elements, the oven vent is located under the left rear surface element. When the oven is on, warm air flows through the left rear element. This venting is necessary for proper air circulation in the oven and good baking results. DO NOT BLOCK THE OVEN VENT.
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO
OPERATING THE OVEN). Always use oven mitts when using the oven.
Removing & Replacing Oven Racks
To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.
Setting Clock & Minute Timer (some models)
Models with no Clock
If your model has no Clock or Minute Timer, clock settings are not required to operate your range. Please proceed to Setting Surface & Oven Controls in this Use & Care Manual.
To Set the 3 Button Clock (some models)
Note: The 3 button clock graphics shown vary by model.
To Set the 3 Button Minute Timer
When the range is first plugged in, or when the power supply to the range has been interrupted, "12:00" will flash in the display window.
1.Slide switch C (CLOCK/TIMER) to the CLOCK position.
2.Push in and hold button A (HOUR) until the correct hour appears in the display. (The numbers will only count forward.)
3.Push in and hold button B (MINUTE) until the correct minutes appear in the display.
1.Slide switch C (CLOCK/TIMER) to the TIMER position, "0:59" (59 MINUTES) will appear in the display window. The timer can be set for any amount of time from 1 minute to 1 hour and 59 minutes.
2.• To set a time more than 59 minutes, push in and release button A (HOUR). The display will show the maximum 1 hour and 59 minutes. The time can now be adjusted down by pushing in and holding button B (MINUTE) until the correct time appears in the display window.
•To set a time less than 59 minutes, push in and hold button B (MINUTE) until the correct minutes appear in the display. (The minute timer will automatically start when the button is released.)
3.When the set time has passed, the control will display "0:00" and beep continuously. Slide switch C (CLOCK/TIMER) to the CLOCK position to cancel the timer and return to the clock mode.
5
