Crosley W10097009A, W10096992A warranty Troubleshooting, Part Number Accessory

TROUBLESHOOTING cont.

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

to possibly avoid the cost of a service call.

If you experience	Possible Causes	Solution
Cycle time too short	Sensor cycle ending early.	The load may not be contacting the sensor strips. Level the
		dryer.
		Use Timed Dry for very small loads. Change the Dry Level
		setting on Sensor Dry/Auto Dry cycles.
		Increasing or decreasing the Dry Level setting will change the
		amount of drying time in a cycle.
Lint on load	Lint screen clogged.	Lint screen should be cleaned before each load.
Stains on load or drum	Dryer fabric softener not properly	Add dryer fabric softener sheets at the beginning of the cycle.
	used.	Fabric softener sheets added to a partially dried load can stain
		your garments.
		Drum stains are caused by dyes in clothing (usually blue jeans).
		These will not transfer to other clothing.
Loads are wrinkled	Load not removed from dryer at the	Select Wrinkle Prevent feature to tumble the load without heat
	end of the cycle.	to avoid wrinkling.
	Dryer tightly packed.	Dry smaller loads that can tumble freely to reduce the chance
		of wrinkles forming.
Odors	You have recently been painting,	Ventilate the area. When the odors or fumes are gone from the
	staining, or varnishing in the area	area, rewash and dry the clothing.
	where your dryer is located.
	The electric dryer is being used for	The new electric heating element may have an odor. The odor
	the first time.	will be gone after the first cycle.
Load is too hot	Laundry items were removed from	Allow Cool Down cycle to finish before removing laundry from
	the dryer before the end of the	dryer. All cycles are cooled slowly to reduced wrinkling and
	cycle.	make it easier to handle. Items removed before Cool Down may
		feel very warm.
	A high temperature cycle was used	Select a lower temperature, and use a Sensor Dry/Auto Dry
	or TEMPERATURE control was set	cycle. These cycles sense the temperature or the moisture level
	to high.	in the load and shut off when the load reaches the selected
		dryness. This reduces overdrying.

Accessories

Enhance your dryer with these premium accessories.

For more high-quality items or to order, call 1-800-901-2042, or visit us at www.applianceaccessories.com. In Canada, call 1-800-807-6777or visit us at www.whirlpoolparts.ca.

Part Number	Accessory
3404351	Drying rack – fits 29" (737	mm)	Super
	Capacity, 6.5 cu. ft. (0.18 cu. m) –
	side swing or hamper door
3406839	Drying rack – fits 29" (737	mm)	Super
	Capacity Plus, 7.0 cu. ft. (0.20 cu. m) –
	side swing door only

12