Location Requirements
You will need
■A location that allows for proper exhaust installation. See “Venting Requirements.”
■A
■A grounded electrical outlet located within 2 ft (610 mm) of either side of the dryer. See “Electrical Requirements.”
■A sturdy floor to support the dryer weight (dryer and load) of 115 lbs (52 kg). The combined weight of a companion appliance should also be considered.
■A level floor with a maximum slope of 1" (25 mm) under entire dryer.
Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended.
Minimum spacing for recessed area and closet installation
The following dimensions shown are for the minimum spacing allowed when the dryer is to be operated with, or without, the Stack Stand Kit. To purchase a Stack Stand Kit, see “Assistance or Service.”
■Additional spacing should be considered for ease of installation and servicing.
■Additional clearances might be required for wall, door, and floor moldings.
■Additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer.
■For closet installation with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.
■Companion appliance spacing should also be considered.
Recessed or closet installation - Dryer only
14"* |
|
|
(356 mm) |
|
|
| 18"* (457 mm) |
|
3"* | 1" | 1" |
(76 mm) | (25 mm) | (25 mm) |
A | B |
|
A. Side view - closet or confined area
B. Recessed area
Recessed or closet installation - Stacked
The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.
Installation Clearances
The location must be large enough to allow the dryer door to open fully.
Dryer Dimensions
*20 3 4" 
(527 mm)
12"* | 3"* |
(305 mm) | (76 mm) |
| DRYER |
12"* |
|
(305 mm) |
|
| WASHER |
1" |
|
|
|
|
|
|
|
|
|
|
| 1" 1"* |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
| ||||||||||||
(25 mm) |
|
|
|
|
| (25 mm) (25 mm) |
| |||||||||
48 in.2* (309.7 cm2)
24in.2 *
(154.8 cm2)
3"* (76 mm)
3"* (76 mm)
31"†
(787 mm)
23 7 8"
(606 mm)
†Height with caster is 32½" (826 mm)
*Most installations require a minimum 5" (127 mm) clearance behind the dryer for the exhaust vent with elbows. See “Venting Requirements.”
AB C
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
Mobile Home - Additional Location Requirements
This dryer is suitable for mobile home installations. The installation must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 245, HUD Part 280) or Standard
4
