4

Control Locators

Unit Controls

1FM Tuner
2Tuning
3Light On / Off
4Power
5Program Indicator
6Repeat Indicator
7Play / Pause Indicator
8Mute Indicator
9Remote Sensor
10 Stand By Indicator
11 Power Indicator
12 CD Drawer
13 Remote Holder
14 Speaker Int. & Ext.
15 Speaker Jacks
16 FM Antenna
17 A/C Power Cord
18 Line In Jack
19 Line In ON/OFF Switch
20 Stage light Stop & Run Switch
LINE IN LINE IN
ON OFF
SPEAKER
R SP- L
INT.EXT.
STOP RUN
STAGE LIGHT
R SP+ L
19
18
15
14
16
13
17
20
10
11
8
9
5
6
7
12
4
23
1
1This radio is equipped with external speaker
outputs.
2The speaker jacks for external speakers are
located on the back of the radio. Beside the
speaker jacks is a switch labeled (int./ext.) When
using external speakers, this switch must be
switched to the ext. position. Doing this turns off
the internal speakers in the radio and redirects
to power to the external speakers.
3If you decide not to use the external speakers,
be sure the switch is on int. or the internal
speakers will not work.
1You can connect external components to your
unit by using the Auxiliary Inputs.
2Plug one end of the supplied auxiliary cable into
the LINE IN JACK (18) on the back of the
jukebox.
3Switch the LINE IN ON/OFF (19) to the ON
position.
4Plug the other end other auxiliary cable into the
output jack of your external device.
5Check the volume level of your external
component.
6See operators manual for correct operation of
the external component.

External Speakers

Auxiliary Inputs

Lights / Bubble Tubes

FM Stereo Operation

Remote Control

7

Basic Operation

Connecting Optional Equipment

1Gently pull on top right side of tuner door to open.
2Press light button in to turn lights on.
3Bubble tubes will begin to bubble in approximately
15-20 minutes after lights are turned on.
4Bubble tubes will not bubble unless lights are on.
1Press the Power (21) button to turn the power
ON/OFF.
2Press CD/RADIO (26) to select the CD player or
radio mode.
3Use VOL+ (31) and VOL- (32) to adjust the
volume level.
4Press the MUTE (29) button to mute the volume
completely.
5The remaining controls are specific to the CD
player. See CD OPERATION for information on
CD player.
1T urn power on using either the remote or power
button located behind tuner door.
2Press CD / RADIO BUTTON (26) to enable FM
tuner.
3Turn the Tuning (2) wheel to set the FM dial to
the desired station.
4Position FM ANTENNA (16) for best reception.
5Set the volume to the desired listening level by
using the remote control.