Crosley Radio CR79 instruction manual Basic Operation, Radio

Press the “VOL-” button to decrease the volume.

Electronic volume control display

Basic Operation

Powering Up Your Crosley

Your new Crosley is equipped with a POWER / STANDBY button. Press the POWER / STANDBY button on either the front of the unit or on your remote control. The Standby light will turn from red to green. When turned off, the standby light will turn red. During standby mode, all presets will remain programmed in your unit.

Functions

Electronic Volume Control

1 Press the “VOL+” button to increase the volume.

The volume level will be shown in the LCD display.

Note: Volume range for this units start at level 0 and end at level 40.

2

3 Press and hold either the “VOL+” or the “VOL-” button to continuously increase or decrease the volume. The volume will continue to increase or decrease until the button is released.

4 Press the “MUTE” button to set the volume to 0.

Press the “MUTE” button again to return to the previous volume level.

Functions (cont.)

Function Select

1 Press the “TUNER/BAND” button to enable the AM/ FM tuning function. When in TUNER mode, the LCD will display the band (AM/FM), and the station frequency.

Receiving tuning frequency display

2 Press the “CD” button to set to CD mode. When first set to CD mode, the display will search for CD and track information.

CD TOC reading display After reading display

3 Press the “PHONO” button to set to PHONO

mode. When in PHONO mode, the display will read “PHONO”.

PHONO display

4 Press the “TAPE” button to set to CASSETTE mode. The display will read “COUNTER” when in cassette mode.

TAPE mode display

Load Preset Channel

Load up and down correspond to “PS+” and “PS-” key, respectively.

APress “PS+” or “PS-“ to recall preset channel

Notes: 1) the current display frequency will not be kept during above operation.

In FM band	Preset channel_2
	loaded

Preset “PS+” to target preset channel

Save Preset

Channel number select up or down correspond to “PS+” and “PS-” key, respectively.

a)In TUNER mode, choose a station that you want to save. Press “PROG” to enter programming mode.(--) will flash.

b)Press “PS+” or “PS-“ to desired preset number (e.g. channel-10).

c)Press “PROG” to save that station.

d)Repeat above procedure.

Notes: 1) The original preset of channel-2 will not be changed during above operation.

In FM band with preset channel In FM band without preset channel

Radio

Mono/Stereo

APress “MO/ST” to toggle the type of FM signal.

Notes: 1. Only for FM band

2.If stereo signal is too weak, ‘STEREO’ icon will not appear. Press this key change to Mono mode. The reception may be improved.

In FM band (Current mode =Stereo)

Change to	press “MO/ST”
MONO mode

press “MO/ST”

Signal

A high-pitched noise called BEAT is sometime heard during reception of radio broadcast.

A	Press “SIGNAL”	In FM band
	until find a best
	quality of signal.
		choose 1st	press”Signal”
		method

Equalizer

1 This unit has a built in equalizer. The equalizer fine tunes the sound according to the type of music you like. Pressing the EQ button results in the following changes:

FLAT ROCK Jazz

CLASSIC POP

Equalizer “ROCK”

press “PROG”

end of prest

enter to PRESET	press “PROG”
SETTING mode

Channel number	press “PS+/PS-”
	to a desired
selection	channel number

choose 2nd	press”Signal”
method

choose best sound quality after 3sec waiting

7

press “PROG”

16