Crown Audio 140MPA operation manual Remote Volume Control

Commercial Audio Series Mixer-Amplifiers

2 Setup

2.8 Remote Volume Control

You can remote-control the output volume of the 140MPA. To do so, locate the OUTPUT VCA connector on the back panel. Insert a 4-pin Phoenix-type cable connector into the OUTPUT VCA connector. Wire a Crown 1-VCAP level control to the Phoenix-type cable connector ter- minals as shown in Figure 2.12.

Output VCA Connector

Phoenix-type plug

Figure 2.12 Wiring a 1-VCAP Level Control to the Output VCA Connector

Output VCA Connector

page 12 Operation Manual