![2.5 Wire Your System](/images/new-backgrounds/19305/1930521x1.webp)
Commercial Audio Series Business Music System
2 Setup
2.5 Wire Your System
Typical input and output wiring is shown in Figure 2.11.
INPUTS: Connect microphones or balanced
OUTPUTS: Maintain proper polarity
Connect the Amplifier Output screw terminals to loudspeakers. Use ter- minals marked COM and 25V or 70V for
Connect the COM terminal to speaker negative
2.6 Phantom Power
Condenser mics require phantom power to operate. If you are using a condenser microphone with the 180MAx on Input 1, turn on the Phan- tom Power Switch on the back of the
2.7 Link In/Out Switch
This switch (Figure 2.11) affects which signals are heard when another mixer is wired to the
IN: Any signal applied to the AMP INPUT connector will be mixed with the input signal(s).
OUT: Only the signal from the AMP INPUT connector will appear at the amplifier output.
How to link another mixer to your mixer-amplifier:
Connect the extra mixer’s LINE OUT connector to the
How to set up Music-On-Hold output:
Connect
How to set up a processing loop:
Connect
CD/DVD player
Satellite receiver
70V speakers
(four JBL Control 1ST speakers supplied only with 180MAx Pack)
CONNECT 70V SPEAKERS
OR
BUT NOT BOTH.
XM antenna
One
or two 8-ohm speakers in parallel
Figure 2.10 Input and Output Wiring
Figure 2.11 Link In/Out Switch
Operation Manual | page 11 |