CP660 Power Amplifier
3 Setup
3.1 Unpack Your Amplifier
YOU WILL NEED (not supplied):
•Input wiring cables
•Output wiring cables
•Rack for mounting amplifi er (or a stable surface for stacking)
WARNING: Before you start to set up your amplifier, make sure you read and observe the Important Safety Instruc- tions found at the beginning of this manual.
3.2 Install Your Amplifier
CAUTION: Before you begin, make sure your amplifier is disconnected from the power source, with power switch in the “off” position and all level controls turned completely down (counterclock- wise).
Use a standard
You may also stack amps without using a cabinet.
NOTE: When transporting, amplifi ers should be supported at both front and back.
3.3 Ensure Proper Cooling
When using an equipment rack, mount units directly on top of each other. Close any open spaces in rack with blank panels. DO NOT block side or front air vents.
Figure 3.2 illustrates standard amplifier air- flow.
Figure 3.2 Airflow
Figure 3.1 Dimensions
page 6 | Operation Manual |
