K Series Power Amplifiers
6 Troubleshooting
CONDITION: No power to the amplifier.
POSSIBLE REASON:
•The amplifier's Power switch is off.
•The amplifier is not plugged into the power receptacle.
•The amplifier's
CONDITION: Distorted sound.
POSSIBLE REASON:
•Input signal level is too high. Turn down your amplifier level controls. NOTE: Your amplifier should never be operated at a level which causes the Clip LED to flash constantly.
•Load is wired incorrectly or Bridge Mono Switch is set incorrectly. Check both.
Note: If sound is distorted but clip LED is not flashing, check mixer levels and gain staging, mixer clip lights, and pads built into micro- phones.
CONDITION: Input signal but no sound.
POSSIBLE REASON:
•The amplifier has just been turned on and is still in the
•Speakers not connected.
CONDITION: No input signal.
POSSIBLE REASON:
•Input signal level is very low.
•Level controls are turned down.
•Input cables are not connected.
CONDITION: TLC indicator glows brightly.
POSSIBLE REASON:
•The amplifier is protecting itself with the thermal level control system. Turn on a fan or turn down the level controls.
page 14 | Operation Manual |