Crown Audio operation manual Setup, M Series Power Amplifiers, page, Bridge-MonoMode

M Series Power Amplifiers

2 Setup

2.6.2 Bridge-Mono Mode

Typical input and output wiring is shown in

Figure 2.9.

Set the Mode Switch to Bridge.

INPUTS: Use only the Channel-1 input connec- tor.

NOTE: Crown provides a reference of wiring pin assignments for commonly used connector types in the Crown Amplifier Application Guide available at www.crownaudio.

OUTPUTS: If you are using the 5-way binding posts, connect the speaker across the red bind- ing post of each channel. Do not use the black binding posts when the amp is being operated in Bridge-Mono mode.

If you are using the Speakon® connectors, use only the Channel 1 connector.

NOTE: The Channel 2 level control MUST be turned down (full CCW) when operat- ing the amplifier in Bridge-Mono mode.

Figure 2.9

System Wiring, Bridge-Mono Mode

Operation Manual page 9