4.Run the mic cable through the hole in the elec- trical box. Service the end of the mic cable.
5.Connect the mic cable’s audio hot lead to the terminal labeled AUDIO +. Connect the audio cold lead to the terminal labeled AUDIO
If you plan to use an RCA or phone connector: Sol- der the cable shield to the long lug, and solder the AUDIO + lead to the tip or pin. Do not connect the AUDIO – lead because this may reduce the output level in an unbalanced configuration.
6.Attach the power leads to the screw terminals marked “~”. You can use
7.Using the two shorter screws provided, attach the mic to the electrical box. Then use the other two screws to secure the louvered wall plate to the microphone. Do not remove or damage the plastic membrane.
8.If the mic cable is run in metal conduit, ground loops can occur that can cause hum. If hum is present after installation, return the unit to Crown’s service dept. for
Fig. 3
Architects’ and Engineers’ Specifications
The microphone shall be the Crown model
Warranty
Crown professional microphones are guaranteed against malfunction for a period of three years from date of original purchase. Please refer to the enclosed full warranty statement for more detail.
PZM-11LLWR
Service
If the unit fails to work, recheck all your connec- tions as described in the Installation Section. Check the cables. Also check the power supply to verify that it is supplying correct voltage. A Service Return Authorization (SRA) is required for product being sent to the factory for service. An SRA can be completed on line at www.crownaudio.com/ support/factserv.htm. If service is required, return the microphone in its original packaging to: Crown
Factory Service, 1718 West Mishawaka Road, Elkhart, Indiana
tance or technical support call
Crown International, Inc. 1718 W. Mishawaka Rd. Elkhart, IN
©2008 Crown Audio®, Inc. Specifications subject to change without prior notice. Latest information available at www. crownaudio.com. Crown, Crown Audio, PZM and Pressure Zone Microphone are registered trademarks of Crown International.
1/08 |