XLS Series Power Amplifiers
3 Setup
3.7Wire Your System 3.7.1 Stereo Mode
Typical input and output wiring is shown in Figure 3.6.
INPUTS: Connect input wiring for both channels.
OUTPUTS: Maintain proper polarity
Connect Channel 1 positive (+) speaker load to Channel 1 positive (red) terminal of amp; repeat for negative
3.7.2 Bridge-Mono Mode
120V |
110V |
Figure 3.6. System Wiring, Stereo Mode
Typical input and output wiring is shown in Figure 3.7.
INPUTS: Use a custom “Y” adapter cable, wired to split the signal and invert the polarity for the Channel 2 amplifi er input as shown in Figure 3.8. We recommend you label the ends of the Y adapter to help make sure to connect the correct end to each amplifi er input.
Connect the Y adapter between the signal source and each amplifi er input.
NOTE: Crown provides a reference of wiring pin assignments for commonly used connector types in the Crown Amplifier Application Guide (Section 1.21.) available at www.crownaudio.
OUTPUTS: Connect the speaker across the red binding post of each channel. Do not use the black binding posts when the amp is being operated in
NOTE: The Channel 1 and 2 level con- trols MUST be set to identical settings when operating the XLS amplifier in
120V |
110V |
Figure 3.7. System Wiring,
Figure 3.8. Custom Input Cable for
Operation Manual | page 7 |