Crown Audio XLS 202 G.Power Connector H.Fuse, Provides overload protection, I.Voltage Selector

XLS Series Power Amplifiers

4 Operation

4.3Back Panel Controls and Connectors

G.Power Connector

H.Fuse

Provides overload protection.

I.Voltage Selector

Two-position switch is factory-set to coun- try-specifi c voltage. WARNING: Do not operate your amplifier with an incor- rect voltage selected or amplifier damage may result.

J.Male XLR Signal Links

One per channel; male XLR connectors are provided for daisy-chaining to other amplifi ers.

K.Balanced XLR Inputs

One per channel; three-pin female XLR input connectors are provided.

L.Filter Switches

One per channel; three-position switch sets the internal high-pass fi lter frequency. Fre- quency setting is 30 Hz when switch is

in left position; 15 Hz when switch is cen- tered; and bypassed when switch is in right position.

M. Limiter Switch

Offers loudspeaker protection against mod- erate amplifi er clip when set to the “IN” position.

N.5-Way Binding Post Output Jacks One pair per channel; accept banana plugs, spade lugs or bare wire. Note: Binding post outputs on European models come with safety plugs installed to prevent banana plugs from being inserted. Note that it is possible to lever the caps out of the bind- ing posts, but this will invalidate the prod- uct safety approvals in some territories. The side entry positions for these connec- tors should therefore be used if possible.

Figure 4.2 Back Panel Controls

and Connectors

page 10 Operation Manual