XLS Series Power Amplifiers
7 Specifications
Minimum Guaranteed Power (watts) | XLS202 | XLS402 | XLS602 |
120 VAC, 60 Hz Units, per channel, both channels driven |
|
|
|
1 kHz with 0.1% THD |
|
|
|
Stereo, 2 ohm (per ch.) | 250 | 570 | 840 |
Stereo, 4 ohm (per ch.) | 200 | 400 | 600 |
Stereo, 8 ohm (per ch.) | 145 | 260 | 370 |
240 VAC, 50 Hz Units, per channel, both channels driven |
|
|
|
1 kHz with 0.1% THD |
|
|
|
Stereo, 2 ohm (per ch.) | 260 | 610 | 880 |
Stereo, 4 ohm (per ch.) | 225 | 445 | 670 |
Stereo, 8 ohm (per ch.) | 155 | 275 | 400 |
Performance | XLS202 | XLS402 | XLS602 |
Sensitivity (volts RMS) |
|
|
|
for full rated power at 4 ohms | 0.725 | 1.025 | 1.26 |
Frequency Response (at 1 watt) 20Hz - 20kHz | ± 0.75 dB | ± 0.75 dB | ± 0.75 dB |
Phase Response (degrees at 1 watt) |
|
|
|
at 10 Hz | |||
at 20 kHz | +19 | +19 | +19 |
Signal to Noise Ratio (20 Hz to 20 kHz) |
|
|
|
| > 100 dB | > 100 dB | > 100 dB |
No weighting, below rated power | > 97 dB | > 97 dB | > 97 dB |
Total Harmonic Distortion (THD) |
|
|
|
at full bandwidth power, from 20 Hz to 1 kHz | < 0.15% | < 0.15% | < 0.15% |
Intermodulation Distortion (IMD) |
|
|
|
60 Hz and 7 kHz at 4:1, from full rated output to | < 0.3% | < 0.3% | < 0.3% |
|
|
|
|
Damping Factor (8 ohm) 10Hz to 400Hz | > 200 | > 200 | > 200 |
Crosstalk, below rated power |
|
|
|
at 1 kHz |
| ||
at 20 kHz |
| ||
Input Impedance |
|
|
|
nominally balanced, nominally unbalanced | 20 k ohms, 10 k ohms | 20 k ohms, 10 k ohms | 20 k ohms, 10 k ohms |
Load Impedance (rated) |
|
|
|
Note: Safe with all types of loads. |
|
|
|
Stereo |
| ||
| 8 ohms | 8 ohms | 8 ohms |
Voltage Gain (at maximum output) | 31 dB | 31 dB | 31 dB |
AC Line Voltage and Frequency Configurations Available (±10%) | 120 VAC/60 Hz and 230 VAC/50 Hz | 120 VAC/60 Hz and 230 VAC/50 Hz | 120 VAC/60 Hz and 230 VAC/50 Hz |
Operation Manual | page 13 |