Xs Series Power Amplifiers

2 Setup

2.6 Wire Your System

2.6.1 Stereo Mode

Typical input and output wiring is shown in

Figures 2.8 and 2.9.

INPUTS: Connect input wiring for both channels.

OUTPUTS: Connect speakers to the 5-way binding posts or to the two Speakon® connectors. See the details below.

Connection to 5-way binding posts:

1.Connect speaker 1 positive (+) lead to the amp’s Channel-1 positive (red) binding post.

2.Connect speaker 1 negative (–) lead to the amp’s Channel-1 negative (black) binding post.

3.Connect speaker 2 positive (+) lead to the amp’s Channel-2 positive (red) binding post.

4.Connect speaker 2 negative (–) lead to the amp’s Channel-2 negative (black) binding post.

Connection to Speakon® connectors:

1.Connect speaker 1 positive (+) lead to the amp’s Channel-1 Speakon® terminal 1+.

2.Connect speaker 1 negative (–) lead to the amp’s Channel-1 Speakon® terminal 1–.

3.Connect speaker 2 positive (+) lead to the amp’s Channel-2 Speakon® terminal 1+.

4.Connect speaker 2 negative (–) lead to the amp’s Channel-2 Speakon® terminal 1–.

2.6.2 How to Parallel the Inputs

There are three ways to feed the same signal to each amplifier channel:

1.Buy a “Y” cable. Plug the female end into your signal cable, and plug the split male ends into both amplifier inputs.

2.Feed your signal to the Channel-1 input (either Phoenix or combo). Connect a jumper wire (Figure 2.9) between the Phoenix Channel-1 (+) screw terminal and the Channel-2 (+) screw termi- nal. Connect another jumper wire between the Channel-1 (–) screw terminal and the Channel-2 (–) screw terminal.

3.Feed your signal to the Channel-1 Phoenix terminals. Using a mic cable or phone-to-phone cable, connect Channel-1 combo jack to Channel-2 combo jack.

CHANNEL 2

CHANNEL 1

Figure 2.9

Phoenix Connector Wiring for

Parallel Inputs

Figure 2.8

Stereo Wiring

page 8

Operation Manual

Page 8
Image 8
Crown Audio Xs Series Wire Your System Stereo Mode, Typical input and output wiring is shown, How to Parallel the Inputs