Xs Series Power Amplifiers

2Setup

2.6.3Bridge-Mono Mode

Typical input and output wiring is shown in

Figure 2.10.

NOTE: Crown provides a reference of wiring pin assignments for commonly used connector types in the Crown Amplifier Application Guide available at www.crownaudio.

OUTPUTS: Connect the speaker across the red binding posts of each channel. Do not use the black binding posts when the amp is being oper- ated in Bridge-Mono mode.

IMPORTANT: Set the Bridge/Normal switch to “Bridge.”

NOTE: In Bridge-Mono mode, only the

Channel 1 Level control is functional.

Figure 2.10 Bridge-Mono Wiring

Operation Manual

page 9

Page 9
Image 9
Crown Audio Xs Series operation manual Bridge-Mono Mode, Channel 1 Level control is functional