6.Slide the hinge pin into the hole located on the mounting tab, as in Fig. 4-12. Use the cut-out window (See inset in Fig. 4-12) to line up the hinge pin on the other side and push pin all the way in until it reaches the end-stop. At this point the pin clips into place and is secured by a tab in the bagger cover. See Fig. 4-13.

7.Open Hood by pushing in on the rear, right-side tab with your right hand, as seen in 1 of Fig. 4-14, and lifting the cover with your left hand in the center rear of the bagger cover, 2.

2

 

1

 

Figure 4-14

8.

Install the bag assemblies onto the bag support brackets

Figure 4-12

by inserting the front edge in first, as seen in Fig. 4-15, and

setting the back edge down until it fits into the assembly.

 

1

2

Figure 4-13

Figure 4-15

Section 4 — Assembly & Installation

 

11