Cub Cadet 19HP Enforcer 44, 21HP Enforcer 48, 23HP Enforcer 54 service manual Steering Levers

Steering Levers

Figure. 3 Deck Lift Pedal

4.Electric Blade Clutch Switch: (See Figure 1.) Located on the right side of the mower beside the ignition switch. This is an “on/off” push-pull switch that controls the electric blade clutch which supplies power to the cut- ting blades through the PTO. The switch must be turned off to start the engine and should be turned off for safety any time another per- son approaches the mower or the mowing deck is raised to the transport position. Power to the electric clutch will also be cut off if the operator leaves the operator’s seat.

5.Parking Brake: (See Figure 3.) Located on the left side of the traction unit. The handle is an overcenter lever which applies the drum brakes on the drive wheels when the handle is pulled to the rear. The brake must be engaged in order to start the engine.

6.Deck Lift Pedal: (See Figure 3.) Located on the panel in front of the seat. Raise the mow- ing deck to the transport position, by pushing the upper part of the pedal. To lower the mow- ing deck, push on the upper part of the pedal and lower it to the desired position.

7.Fuel Shutoff Valve: (See Figure 4.) Located on top of each fuel tank. When turned in a clockwise direction until it stops, it will shut off the flow of fuel to the engine. When turned in a counterclockwise direction it will open and allow fuel to flow to the engine. Close this valve if you are not going to run the mower for a period of 30 minutes or more to prevent flooding the engine.

Figure. 4
	Fuel Shutoff Valve

8.Seat Position Adjustment Lever: The Seat Position Adjustment Lever is located beneath the seat. The Seat Position Adjustment Lever is used to move the seat forward and back- ward. To place the seat in the desired position pull the seat adjustment lever to the left then push the seat forward or back to the desired position. Release the lever so the seat will lock in place.

9.Weight Adjustment Lever: The weight adjustment lever is located on the right side of the seatback and incorporates three settings: upper is 110 lbs, middle is 195 lbs, and lower is 285 lbs.

10.Seatback Recline Knob: The seatback recline knob is located on the right side between the seat back and seat bottom. Turning it clockwise adds additional recline up to 10 degrees.

11.Hour Meter: (See Figure 1) Located on the right side of the mower behind the ignition switch. The hour meter displays running time.

Note: An optional meter provides engine speed (RPM), service reminders (oil, lube), and running time (hours).

12.Choke Lever: (See Figure 2) The Choke knob is located on the left side control panel next to the operator’s seat. Having the Choke in the ON (up) position helps the engine to start during initial start-up. During normal operation the Choke should be in the OFF (down) position.

12