Figure.7Spindle
Note: When replacing belts do not over- tighten. Adjust the idler pulley so that a ten- pound pull with a spring scale between two pulleys deflects the belt about 1/2".
Hydrostatic
Transaxles
Figure. 8
C.Electrical Circuit
Danger:
Read General Safety Precautions Nos. 9 and 10.
5.Changing the Spindle Assembly
a.Jack up the front of the mowing deck about one foot and block it in that position.
b.Make sure the blade clutch is disengaged.
c.Remove the deck cover.
d.Remove the drive belts. (See 3. Changing Blade Drive Belts.)
e.Remove the cutter blade. (See 2. Chang- ing a Blade.)
f.Using a wrench or socket ratchet remove four hex nuts, and the four hex head cap screws. Remove the spindle assembly.
g.Reverse the process to install the spindle assembly.
B.Hydrostatic Drive System
1.Your zero turn riding mower is equipped with dual integrated hydrostatic pumps, motors, and planetary gear reduction transaxles that are sealed and do not require service, maintenance, or adjustments.
17
1.Battery: The battery is located beneath the operator’s seat. If so equipped, remove the fill- caps and check the level of the liquid electro- lyte in the battery every 50 operating hours. If the level in any of the six cells has dropped below the bottom of the split ring inside the fill hole, refill the cell with distilled water. To keep the outside of the battery clean, brush on a strong solution of bicarbonate of soda and water and rinse with clean water. Keep the contacts and cable ends clean with a wire brush and make sure the connections are tight. Coat the terminals with petroleum jelly to prevent corrosion.
2.Battery Removal
Warning:
When removing the cables from the battery follow these steps to avoid a short between the wrench and the frame.
a.Remove the negative (black) cable.
b.Remove the positive (red) cable.
c.Release the hold down straps.
d.Remove the battery without tipping.
3.Battery Storage: When storing the mower for long periods of time the following guidelines should be performed.
a.Disconnect the battery cables from the ter- minals and remove the battery.
b.Clean the battery before storing. A dirty battery will lose its charge over time.
