Grizzly G8622 instruction manual Beginning Assembly, Switch Pedestal, Handwheel

SECTION 4: ASSEMBLY

Keep clothing rolled up and out of the way of machinery and keep hair pulled back.

Disconnect power to the machine when perform- ing any maintenance or assembly. Failure to do this may result in serious personal injury.

Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.

Some metal parts may have sharp edges on them after they are formed. Please examine the edges of all metal parts before handling them. Failure to do so could result in injury.

Beginning Assembly

Most of your Model G8622 Shaper has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented in this section.

Switch Pedestal

Turn the switch pedestal upright to install it on the back of the shaper. Have another person hold it in place, then reach inside and thread the nuts onto the bolts.

Handwheel

The handwheel, pre-installed at the factory, is made of cast iron. It is used to raise and lower the spindle to accommodate the height required by your cutter.

Thread the crank handle onto the handwheel and tighten with a 12 mm wrench.

Crank Handle

Figure 5. Handwheel mounted to shaper.

G8622 Tilting Spindle Sliding Table Shaper -11-