The miter fence can be adjusted by loosening the two bolts that hold it to the miter gauge and then sliding it in the desired direction.

The support fence slides up and down the miter fence and can be locked to hold the back of the workpiece in place.

The miter clamp holds the workpiece firm against the table and keeps it in position against all of the associated fences.

To use the miter assembly:

1.Determine the angle of cut and set the miter gauge to that angle, without tightening it yet. (The angle of the miter gauge should be determined by the angle of the workpiece you are about to shape.) Lock the miter gauge in place.

2.Move the infeed and outfeed fences out of the way. Hold the workpiece flush against the miter fence and slide the workpiece and table toward the cutter. Line the workpiece up with the cutter.

3.Slide the support fence to the back of the workpiece and lock in place.

4.Clamp the workpiece to the table with the miter clamp as shown in Figure 47.

5.The workpiece is now ready for the cut.

Figure 47. Locking down the miter clamp.

Shaper Accessories

There are many accessories that can be built or purchased to increase the safety of the operator. Many experienced shaper users regularly use proven shop-made fences and safety guards to augment their shaping operations. In addition, many production shops routinely use power feed- ers with their shapers to streamline their opera- tions.

Here are some basic accessories and their uses:

Zero Clearance Fence — A shop-made fence with an opening only as large as the cutter, so that only the part of the cutter being used is exposed.

Box Fence — A shop-made box that com- pletely surrounds the cutter. A one-piece fence is attached that allows only the thick- ness of the board to pass underneath, there- by completely shielding the operator from exposure to the spinning cutter. A clear plex- iglass window on top of the box allows the operator to view the workpiece during cut- ting.

Power Feeder — A motorized unit that can be clamped or permanently mounted to the table of a shaper. A power feeder pulls the workpiece through the cut, reducing the risk of operator contact with the spinning cutter and reducing any injuries due to kickback. Because of the steady feed rate, power feed- ers can also produce cleaner, more consis- tent cuts. Check the current Grizzly catalog for available power feeders.

Because of the wide range of fences and guards that can be built in the shop, explaining their con- struction is beyond the scope of this manual. We strongly recommend that you read shaper books, trade magazines, or get formal training to learn more about these.

 

 

 

 

 

 

 

 

-30-

 

 

G8622 Tilting Spindle Sliding Table Shaper

 

 

Page 32
Image 32
Grizzly G8622 instruction manual Shaper Accessories, Locking down the miter clamp