Guard |
| Fence Assembly |
|
|
|
|
|
|
|
|
|
|
|
|
To mount the cutter guard to the table, place the guard over the threaded holes on the table, and insert the shaft guide into the guard as shown in Figure 13. Thread the shaft guide clockwise to secure the guard to the table.
Figure 13. Inserting shaft guide into guard.
Insert the adjustment guide into the screw brack- et. Line up the shaft groove shown in Figure 12 with the center bolt and screw the bolt into the groove as shown in Figure 14. Do not complete- ly tighten the bolt. This will allow the shaft to spin without coming out.
Figure 14. Tightening bolt into shaft groove.
To mount the fence brackets to the guard body:
1.Make sure all rust protective grease has been removed from the fence pieces. Insert the adjustment shaft into the fence bracket as shown in Figure 15.
Figure 15. Adjustment shaft to fence bracket.
2.Insert the adjustable handle (Figure 16) into the fence bracket, and thread it into the guard body.
Figure 16. Adjustable handle.
|
|
|
|
|
|
|
|
|
| G8622 Tilting Spindle Sliding Table Shaper | |
|
|
