Hold-Downs

 

Miter Assembly

 

 

 

 

 

 

Hold-downs are used to hold the workpiece flat on the table and snug against the fence as shown in Figure 19. To assemble the spring hold- downs:

1.Slide a hold-down plate into each of the cast iron hold-down brackets.

2.Insert the bracket pole into the fence bracket and hold-down bracket.

3.Partially screw the handle into the hold-down brackets.

4.Position the hold-downs according to the size of your workpiece.

5.Tighten the handles to secure the hold- downs.

Figure 19. Hold-downs on workpiece.

-16-

The miter gauge for the Model G8622 features a clamp and special fence. The miter gauge assembly can be mounted on either end of the table, depending on the type of desired cut or cut- ting direction. To mount the miter gauge and its fence:

1.Locate the threaded holes on either side of the table.

2.Install the push shaft as shown in Figure 20.

Figure 20. Installing the push shaft.

3.Now, slide the miter gauge down the push shaft as in Figure 21.

Figure 21. Installing the miter gauge. G8622 Tilting Spindle Sliding Table Shaper

Page 18
Image 18
Grizzly G8622 instruction manual Hold-Downs Miter Assembly