HEAD LIGHT BULB REPLACEMENT
LENSES
The tractor is equipped with headlights. If one of the bulbs should burn out, replace the bulb as follows:
•Fully raise the hood.
•Pull the wire harness plug from the bulb/socket assembly to unplug the wire harness. See Figure 35.
NOTCH
SCREW
BULB SOCKET
REFLECTOR
WIRE
HARNESS
PLUG
NOTCH
OUTER HOUSING
INNER HOUSING
BULB/SOCKET
ASSEMBLY
Figure 35
•Turn the bulb/socket assembly approximately a quarter turn counterclockwise to align its tabs with the notches of the reflector, then remove from the reflector.
•Replace with a new bulb/socket assembly (Cub Cadet No.
•Align the tabs of the new bulb/socket assembly with the notches of the reflector and insert the bulb.
•Turn the bulb/socket assembly clockwise to lock in place. Push the wire harness plug fully into the bulb socket.
HAZARD BULB REPLACEMENT
Flashing hazard lights are installed on each side of the ROPS. Replace the bulbs as follows:
•Grasp the outer half of the light housing and both the front and rear lenses. Accessing the screws from the notches at the top and bottom of the outer housing, remove the two screws fastening the outer and inner housings together. See Figure 36.
Figure 36
•Remove the outer housing and lenses.
•Push in on the bulb and turn counterclockwise to remove the bulb from the light socket.
•Align the new bulb with the socket slot, push the bulb into the socket, and turn clockwise to lock it in the socket.
•While making certain the lenses engage the front and rear grooves of the inner housing, install the lenses and outer housing. Secure with the two screws.
SERVICING ELECTRICAL SYSTEM
Fuses are installed to protect the tractor’s electrical system from damage caused by excessive amper- age. Always use the same capacity fuse for replacement. If the electrical system does not func- tion, check for blown fuses. See Figure 37
If you have a recurring problem with blown fuses, have the tractor’s electrical system checked by your Cub Cadet dealer.
GOODBAD
Figure 37
30
