Accessing the Fuse Center
The fuse center is located on the inside right of the dash panel. To access the fuse center, remove the dash panel insert by removing the two screws. See Figure 38.
To cover the fuse center, reposition the dash panel insert in the dash and secure with the two screws.
SCREWS
DASH
PANEL
INSERT
Figure 38
Instrument Panel Fuses
The instrument panel’s circuitry is protected by the two fuses in the fuse center. If the instrument panel does not function properly, check the fuses.
•Pull the fuses from the fuse center and check their condition. Replace a blown fuse with the same capacity fuse (3 Amp). See Figure 39.
Relays
The PTO relay and starter relay, located in the fuse center, maintain power to each of those circuits. If one of the circuits is not functioning properly, have your dealer electrically check the relay. See Figure 39.
INSTRUMENT PANEL FUSES (3 AMP)
STARTER |
RELAY |
PTO RELAY
FUSE
CENTER
Figure 39
Main Fuse
The main fuse in the tractor wire harness protects the tractor’s entire electrical system. A blown main fuse will prevent battery current from passing though the harness.
To replace the main fuse:
•Raise tractor hood and remove right side panel.
•Locate the main fuse under the dash panel, along the tractor’s right frame rail. See Figure 40.
WIRE | RT. FRAME | ||||
RAIL | |||||
HARNESS | |||||
| |||||
|
|
|
|
| |
|
|
|
|
| |
DASH
PANEL
FUSE HOLDER |
| MAIN FUSE |
|
Figure 40
•Pull the fuse from the fuse holder and replace with the same capacity fuse (30 Amp). NEVER use a higher amperage fuse.
•Install side panel and lower tractor hood.
Hazard Light Flasher Relay
The flasher relay controls the on/off flashing of the hazard lights. If the hazard lights do not function properly, the flasher relay is probably faulty.
Replace the relay as follows:
•Remove the dash panel insert by removing the two screws. Refer to Figure 38.
•Pull the wire harness from the dash opening. Cut and remove the electrical tape holding the flasher relay to the harness. See Figure 41
•Note the position of the two harness leads; then disconnect the leads from the faulty relay and connect to the new relay.
•Secure the relay to the wire harness with electrical tape. Reposition the wire harness in the dash panel and reinstall the dash insert.
WIRE
HARNESS
TAPE
HARNESS |
|
| FLASHER |
LEADS |
|
| |
|
| RELAY | |
|
|
| |
|
|
|
|
Figure 41
31
