3.Finish securing chute control assembly to chute support bracket with wing nut and hex screw removed earlier. See See Fig. 3-4.

Figure 3-4

4. Check that all cables are properly routed through the cable guide on top of the engine. See Fig. 3-5.

4.Check that all cables are properly routed through the cable guide on top of the engine. See Fig. 3-5.

Set3. -UpFinish securing chute control assembly to chute support bracket with wing nut and hex screw removed earlier.

ShearSeePinsSee Fig. 3-4.

4. Check that all cables are properly routed through the cable A pair of replacement auger shear pins and bow tie cotter pins

g ide on op of the engine. S e Fig. 3-5.

are included with your snow thrower. Store them in your snow thrower’s dash panel until needed. See Fig. 3-5.

Figure 3-6

Chute Clean-Out Tool

The chute clean-out tool is fastened to the top of the auger housing with a mounting clip and a cable tie at the factory. Cut the cable tie before operating the snow thrower. See Fig. 3-7.

Chute Clean-out Tool

Figure 3-5

Figure 3-7

Section 3 — Assembly & Set-Up