SetTire-PressureUp

Before operating, check tire pressure and reduce pressure in

Shear Pins

both tires to between 15 psi and 20 psi.

A pair of replacement auger shear pins and bow tie cotter pins NOTE: If the tire pressure is not equal in both tires, the machine are included with your snow thrower. Store them in your snow may not travel in a straight path and the shave plate may wear thrower’s dash panel until needed. See Fig. 3-6.

unevenly.

Checkingute Clean-Out Tool

Gas & Oil FilOil-LevelUp

The chute clean-out tool is fastened to the top of the auger CAUTION:Warning!TheUsengineextremeis shippedcare whenwithandlingoil the

housing with a mounting clip and a cable tie at the factory. Cut gasoline. Gasolineengineis. Youextremelymust, however,flammablecheckand the oilvaporslevelareprior the cable tie before operating the snow thrower. See Fig. 3-7. explosive. Nevertooperatingfuel the machinethesnowindthroorsweror.Runningwhile thetheengineis

hot or runningwith.Extinguinsufficientshcigarettes,oil can causecigarserious,pipeseanginedother sources of ignitiondamage. and void the engine warranty.

NOTE:ServiceBethesureengineto checkwiththegasolineengineandonoila levelas instructedurfacewithin thethe engineTecumsehstoppedEngine. Operator’s Manual packed separately with

your snow thrower. Read instructions carefully.

1. Remove the oil filler cap/dipstick and wipe the dipstick NOTE:cleanYour. snowSeeFigthrower.3-8. is shipped with oil in the engine.

Fill between high and low marks

Figure 3-8

However, you MUST check the oil level before operating. Refer to 2. Insert the cap/dipstick into the oil filler neck, but do not Tecumseh Engine Operator’s Manual for detailed instructions.

screw it in.

3.Remove the oil filler cap/dipstick. If the level is low, slowly add oil until oil level registers between high (H) and low (L), Fig. 5-1. Refer to the Engine Maintenance section for correct oil viscosity and engine oil capacity.

NOTE: Do not overfill. Overfilling with oil may result in engine smoking, hard starting or spark plug fouling.

4.Replace and tighten cap/dipstick firmly before starting engine.

AdjustmentsTiredingPressureFu l

Before operating,Warning!check tireUseprextremessure andcareducewh npressurehandlingin

Skid Shoes

both tires to gasolinebetween. Gasoline15 psi andis20extremelypsi. flammable and the

The snow throwervaporskidareshoesexplosiveare .adjustedNever fuelupwardthe machineat the factory NOTE: If the tire pressure is not equal in both tires, the machine for shipping purposesor. Adjustwhile themenginedownward,is hot orif runningdesired,.prior may not travelindoorsa straight path and the shave plate may wear to operatingExtinguishthe snow throwcigarettes,r. cigars, pipes and other unevenly.

sources of ignition.

Caution: It is not recommended that you operate

Gas & Oil Fill-Up

this snow throwerWARNING!on graveAlwaysas it cankeepeasilyhandspickandupfeetandclearthrowof loose gravel,Warning!eqcauipmentsing personalmovingUse extremeinjurypartsor. Docdamagerenotwhenusetohandlingthepressurizedsnow

throwergasoline.andGasolinetartingsurroundingis extremelyfluid.propertysVa flammableare. flammableand the. vapors are

explosive. Never fuel the machine indoors or while the engine is

• For close snow removal on a smooth surface, raise skid hot or running. Extinguish cigarettes, cigars, pipes and other

shoes higher on the auger housing. 1sources. Cleanof ignitionaround. fuel fill before removing cap to fuel.

• Use a middle or lower position when the area to be cleared

2Service. A thefu lenginelevel indicatorwith gasois locatedine andinoiltheas instructedfuel tank. Fillin tankhe is uneven, such as a gravel driveway

Tecumsehuntil Enginefuel reachesOperator’sthe fuelManuallevel indictor,packed separatelyFig. 3-9. Bewithcareful NOTE: If you choose to operate the snow thrower on a gravel your snotwtothroweroverfill..Read instructions carefully.

surface, keep the skid shoes in position for maximum clearance

Fuel Level Indicator

Top View

 

 

3-9

betweenFuel Recommendationsthe ground and the

plate.

NOTE: Your snow thr wer is

with oil in the engine.

However, you MUST check

before operating. Refer to

Use automotive gasoline

or low leaded to minimize

To adjust the skid shoes:

for detailed instructions.

Tecumseh Engine Operator’s

combustion chamber deposits) with a minimum of 87 octane.

1.

Loosen the four hex nuts (two on each side) and carriage

Gasoline with up to 10% ethanol or 15% MTBE (Methyl Tertiary

 

 

3-8

 

bolts. Move skid shoesFigureto d sired position. See Fig. 3-8.

Butyl Ether) can be used. Never use an oil/gasoline mixture or

2.

Make certain the entire bottom surface of skid sho is

dirty gasoline. Avoid getting dirt, dust, or water in the fuel tank.

 

against the ground to avoid uneven wear on the skid

DO NOT use E85 gasoline.

 

•

shoes.

 

Refuel in a well-ventilated area with the engine stopped.

3.RetightenDo not smokenutsorandallowboltsflamessecurelyor sparks. in the area where the engine is refueled or where gasoline is stored.

•Do not overfill the fuel tank. After refueling, make sure the tank cap is closed properly and securely.

•Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite. If any fuel is spilled, make sure the area is dry before starting the engine.

•Avoid repeated or prolonged contact with skin or breathing of vapor.

Section 3— Assembly & Set-Up