Cub Cadet 7000 Series manual Starting the Engine, Cold Weather Starting, Stopping the Engine

STARTING THE ENGINE

WARNING: Always sit in the operator’s seat when starting the tractor, Never attempt to start the engine while standing beside the tractor.

WARNING: Never use starting fluids, such as ether, as a starting aid. Severe engine damage or fire could result.

•Check the engine oil and coolant levels.

•Operator must be sitting in the tractor seat.

•Move the throttle handle to the full (FAST) throttle position. Refer to Figure 14.

•Make sure the PTO switch is in the “OFF” position. Note: The PTO light on instrument panel will flash if switch is in ON position.

THROTTLE

HANDLESLOW

FAST

PTO SWITCH

IN ‘OFF’

POSITION

Figure 14

•Either fully depress and hold the brake pedal or engage the parking brake. Note: The parking brake indicator on instrument panel will flash if pedal is not depressed.

•Turn the ignition key clockwise to the "RUN- PREHEAT" position, and observe the glow plug indicator light on the instrument panel. Wait until the glow plug indicator light turns off before cranking the engine.

NOTE: Preheating may not be necessary if the engine has been running and is warm.

•Turn the ignition key to the “START” position and release it as soon as the engine starts; however, do not crank the engine continuously for more than 20 seconds at a time. If the engine does not start within this time, turn the key to “OFF” and wait at least one minute to allow the engine’s starter motor to cool. Try again after waiting.

•After the engine has started, slowly move the throttle lever to the idle position. Allow the engine to idle for approximately three to five minutes before putting the engine under load.

•Observe the instrument panel. If the battery indicator light, oil pressure light, or coolant temperature light comes on, immediately stop the engine. Have the tractor inspected by your Cub Cadet dealer.

COLD WEATHER STARTING

Ensure that the correct viscosity grade of lubricating oil is used for the ambient temperature range in which the engine will run, as shown in the lubrication table in the MAINTENANCE section of this manual. Place the throttle control in the low idle (SLOW) position if the temperature is below 32°F (0°C), then follow the normal engine starting instructions above. Allow the engine additional time to warm up.

USING JUMPER CABLES TO START ENGINE

WARNING: Batteries contain sulfuric acid and produce explosive gasses. Make certain the area is well ventilated, wear gloves and eye protection, and avoid sparks or flames near the battery.

If the battery loses power and is unable to adequately crank the engine to start it, the aid of a booster battery may be necessary. Connect the booster battery as follows:

•Connect the ends of one jumper cable to the positive terminals of both the disabled tractor battery and the booster battery.

•Connect one end of the other cable to the booster battery’s negative terminal.

•Connect the other end of that cable to the engine block or frame of the disabled tractor, as far from the battery as possible.

•Start the disabled tractor following the normal starting instructions previously provided; then disconnect the jumper cables in the exact reverse order of connection.

•Have the tractor’s electrical system checked and repaired as soon as possible to eliminate the need for jump starting.

STOPPING THE ENGINE

•Place the PTO switch in the “OFF” position.

•Place the throttle control as follows:

-If the engine has been operated at low loads, place the throttle control lever in the “SLOW” position and allow the engine to idle for about one minute.

-If the engine has been operated at high load, run the engine at approximately 1/2 throttle for three to five minutes to reduce the engine coolant and oil temperatures. Then move the throttle control to the "SLOW" position.

20